Rack & Pinion+Front Upper & Lower Control Arm+Wheel Hub Kit For 99-06 GMC Chevy
Rack and Pinion Front Upper & Lower Control Arm Wheel Hub Kit. 1x Complete Remanufactured Power Steering Rack & Pinion Assembly - 1821. 1x Front Lower Control Arm + Pre-Assembled Ball Joint (Driver) - K620265.
1x Front Lower Control Arm + Pre-Assembled Ball Joint (Passenger) - K620264. 2x Front Suspension Upper Ball Joint - K6540.
2x Front Outer Tie Rod End Link - ES3492. Rack & Pinion+Front Upper & Lower Control Arm+Wheel Hub Kit For 99-06 GMC Chevy. 2x Stabilizer / Sway Bar End Link - K80631. 2x Front Wheel Hub and Bearing Assembly (6-Bolt w/ ABS) - 515054. How Does Rack and Pinion Steering Work?Rack and pinion steering uses a gear-set to convert the circular motion of the steering wheel into the linear motion required to turn the wheels. The pinion gear is attached to the steering shaft so that when the steering wheel is turned, the gear spins, moving the rack. The axial rod at each end of the rack connects to the tie rod end, which is attached to the spindle. With high reliability, quality and durability. Air tested to ensure reliable performance.
Hydraulic tested to ensure internal bypass of high and low pressures. Using high-quality materials to extend the service life of Products.
Making it easier to turn the wheels. Helping drivers steer by augmenting steering effort of the steering wheel. Symptoms of a Rack and Pinion Leak. Steering wheel hard to turn.
Red or pink fluid leaking from vehicle. Steering wheel does not center. How to Replace the Power Steering Rack & Pinion.Put the wheels in a straight-ahead position. Crack loose all the wheel lug nuts. Raise and support the vehicle with approved jack stands.
Remove the Steering Shaft Coupler Outer Seal and unbolt the upper pinch bolt on the Steering Shaft Coupler assembly. Detach the outer tie rod ends.
Remove any parts required to gain access to the rack mounting bolts, lines and steering coupling. Remove the power steering rack mounting bolts, or crack the power steering high pressure and return lines. Place a drain pan under the vehicle and remove the hydraulic power steering pressure hose and power steering return hose from the power steering rack. Twist and turn and jiggle it out through one of the wheel well openings. Reconnect the Steering Shaft Coupler assembly and bolt the rack back into place.
Reattach the tie rod ends to the steering knuckles. Put the wheels back on and torque the lug nuts to specifications. Remove the return line from the power steering pump and place the end into a bucket. Fill the power steering pump and start the engine until clean fluid comes out of the return hose. Have the front end aligned to reset the toe-in adjustment to specification or the vehicle will handle poorly and wear out the tire quickly.
Bleed the trapped air out of the system. Professional installation is highly recommended. Rack replacement kit, rack and pinion, power rack parts. K620265, K620264, K6540, ES3492, K80631,515054.Power Steering Rack;Steering Rack and Pinion. Steering Gear;Steering Gear Body;Steering Rack;Rack & Pinion. Rack and Pinion Assembly, Rack and Pinion Rack Gear. Do check the condition of the parcels, and check the items before install them.
Power Steering Rack and Pinion. Power Steering Pressure Line Hose Assembly For 03-06 Acura MDX 3.5L V6 SOHC. Right Cassette Timing Chain Guide For 97-10 Ford Explorer 05-10 Mustang 4.0L V6. For 2002-06 Honda CR-V 2.4L 2354CC l4 Power Steering Pressure Line Hose Assembly. 2x Wheel Hub Bearing For 2007-15 Hyundai Santa Fe 2011-15 Kia Sorento V6 Front.